How to Make a Sock Giraffe

I tend to bust through my socks quickly. I hate to admit this, but I must have very pointy toes.


And I am a firm believer when life hands you holey socks, you make stuffed giraffes out of them. This is not a fine science, and it’s best if you have two pairs of socks that are alike in size. But, if you don’t-improvise.

 


To make this sock giraffe, you will need four small socks that are cute in nature, scissors, a tape measure and a sewing machine.
If you have two opposing sock patterns, this makes for one cute giraffe.

 


You will also need a funnel and jasmine rice. You could also use dried beans or corn kernels…but I like the way the jasmine smells.

 


Cut the elastic band off of the opening of one of the pairs of the sock.
Then cut both socks from the top to the bottom on the back side (the side where the heel would touch).

 


Choose one of the two socks to be the giraffe’s head and neck. The other will be the stomach and booty.
The sock you chose for the head/neck, from the toe of the sock, cut two inches up. This will be the mouth.
I chose to take one inch of material out between the toe and the heel from the head/neck sock in order for the giraffe’s head to be proportionate to the body.

 


Turn all of the material inside out and lay flat.
Pin the ‘mouth’ to the ‘head’ by unfolding it first. Then, sew the ‘mouth’ to the ‘head’ first with a simple straight stitch.
Pin the ‘head’ to the body by unfolding it first. Then, sew the ‘head’ to the body’.

 


Time to use up your other pair of socks! Cut from just where the heel seam ends towards the toe of the sock, two inches in width. These will be the back legs. The heel of the sock will create a natural hip for the giraffe.

 


Now, cut the tip of the tow off of the sock to create a straight end for the leg which will be the giraffe’s foot. Turn the leg piece inside out and sew it together, leaving the straight end (giraffe’s foot) open to stuff with rice later. Save the toe piece to attach to the belly later on.

 


Cut the remaining section off of the sock we’ve been using. This will be the giraffe’s belly.
The square section of the sock will create the giraffe’s two front legs. Cut this square section in half.

 


Here is a shot of what the giraffe might look like before we are done sewing it.
I changed up the ears and tail, so don’t get too attached.

 


Remember our belly piece and the toe piece we saved? Sew them together to look like the picture below.

 


Here is the belly sewn together. Isn’t it cute?

 


With the belly piece and the body piece inside out, pin it to the body by starting at where the giraffe’s booty would be until you get to the neck.

 


Sew the belly to the body and straight up into the neck.
When you turn the body/belly right side out, it should look like this, but with the head attached and sewn together as well.
(You will notice that I had forgotten to sew the head to the neck first. Big mistake, please ignore this little oversight.)

 


Once you have sewn the entire seam up through the neck and into the head, leave an opening at the mouth in order to put rice through.

 


I used some leftover material from the second pair of socks to make two triangular ears about an 1” tall by 1 1/2” wide and the tail about 3” long and 1/2” wide. Leave an opening for the rice by sewing together only three sides of each appendage. Fill them each with rice using the funnel if necessary (you don’t need to fill the tail with rice. Pin them close and hand sew the ends.

 


I cut little fringes on the tail for bonus cuteness.

 


Now, it’s time to fill the body with rice. Using the mouth hole that we left open, fill this cute little body with rice until he’s floppy. Sew a seam where the neck meets the body by separating the rice and running a straight stitch back and forth several times. You do this to keep the neck full of rice. Otherwise, the rice will continue to just fill the body up. Pin the mouth closed and hand sew it together.
Pin on the body where the legs and tail will be. Pin on the head where you would like the ears to be.

 


Pin the appendages to the body and hand sew them on.

 


Hand sew the eyes on with a different color of thread by simply going over the same spot several times until it looks like this.

 


This is our cute little giraffe after he has everything sewn on. How cute and floppy is he? Or she?
I guess it’s up to the creator what the giraffe is….

 


My giraffe preferred the name, ‘Mr. Cool’, so I guess he’s a boy. Now, all you have to do is find someone who is in desperate need of a floppy giraffe and give this to them.
I gave mine to my nephew. Who in your life would want a floppy giraffe?

written by

for the entire world. Deal with it.

6 Responses to "How to Make a Sock Giraffe"

  1. Terry says:

    You’ve done it again!!! Your creativity inspires (and depresses) me to no end!!

    Reply
    • Rebekah says:

      Terry-I hate to depress anyone. Just know that for every finished project you see, there are like 5 failures behind it! Hopefully, that will make you feel better. 😉

      Reply
  2. Kathleen says:

    You’re both funny. That’s why I h-a-t-e talented folks. They make it look so easy. HaHaHa. Congratulations on the cute project. Makes people think outside the craft box. LOL !! I hope to put it to use very soon !!! Appreciate the great idea.

    Reply
  3. Tannis says:

    I love the idea. I would probably make a few giraffes and use them for hot or cold packs ( if they are filled with rice. I just wish I could save this document somehow.

    Reply
  4. Alison says:

    I just found this and I’m going to make it for a wee girl I know who loves giraffe’s and is in and out of hospital a lot at the moment

    Reply

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *